"Error: Module is write only"is what I get when I hit browse with the the / in the directory window.
Just a note. This is one of two profiles on the backup. The other one seems to work fine not using ssh.
I connected to ssh, but the application only allows me to sync the "cloudstation" Remote Directory. What do I need to change so that the HPBackup\qdata folder can be sync'd
I received this helpful response from tech support:
Here is how to configure the Acrosync service so it can remain running after a user logs off:
1) Run the Acrosync GUI as administrator to configure the job (in which case the job will be saved unde…
I tried a fresh install of acrosync on a new computer, still cannot access through acrosync, although I can access fine from that PC through a browser.
Yes, they were produced by Acrosync.I checked the acrosync log C:\WINDOWS\system32\config\systemprofile\AppData\Local\AcrosyncClient64/acrosync_client.log
And all it says is
2018/07/19 20:00:06 RSYNC_FINISH Uploaded Y:/: up to date
I'd like to see …
Of Interest for others:
When running as administrator, I was unable to select mapped network drives to backup.The browse didn't see it and when I typed in "Z:/" it threw an error.I ignored the error, closed the program.When I opened the program agai…
I quit the instance from the system tray and acrosync seemed to stop completely (go no emails about backing up.) I did verify that the service was running.Rebooted at 9am and now it's sending emails again, even though it set to sync at 8PM.
Is the c…